00208

€ 93,60 incl. VAT

Order

ks
The touch screen is 4.3 inches.

The display is full color and has a resolution of 480x272 pixels.

Suitable for connecting to the Duet WIFI motherboard.
More >>

The PanelDue is a colour touch screen controller for the Duet and other 3dprinting electronics that support it.

  • The control board and firmware support 3 screen sizes: 4.3", 5" and 7", at two resolutions: 480×272 (4.3-inch displays) or 800×480 pixels (5- and 7-inch displays). Note that the lower resolution of the 4.3” display means that it cannot display as much information on the screen – for example a maximum of 4 extruders, as shown in the picture.
  • 5V power from host 3D printer controller.
  • 2-wire async serial interface with 3.3V signal level (5V tolerant input).
  • Connections to the onboard micro SD card socket as well as the PanelDue serial and power connections are all available via a 10-way ribbon cable.  A 300mm long ribbon cable (maximum recommended length) is available as an option to add to your order.
  • 4-wire cable to connect the PanelDue to your controller board for the serial and power connections. This cable is supplied (1m long)

There is an overview of connecting a PanelDue in the documentation.

Pestré barvy.
Možnost nastavení obrazovky.
Propojení s deskou DuetWifi.

Žádné.

Was this review helpful? Yes (0) No (0)

Contact us!